Starship Teleporter Console
From Galactopedia
The teleporter console is the control station reponsible for controlling a starship's teleporter.
Shown below is the teleporter console of a Ticonderoga Class Starship. Other Alliance starships will have very similar controls.
Short range sensor target selection is entered by double clicking on the desired target on the short range sensors display.
The teleporter targeting system is controled by double clicking on the desired coordinates at the Targeting Scan
Other control functions are indicated below:
1 - Short Range Sensors Power
2 - Short Range Sensors Active / Passive Select
3 - Short Range Sensors ZOOM OUT
4 - Short Range Sensors ZOOM IN
5 - Short Range Sensors CENTER on selected target
6 - Activation Delay Timer - displays the delay in seconds between pressing a Sequence Initiator button and initializing teleport
7 - Sequence Initiator SEND button - will initialize teleport to targetted coordinates
8 - Sequence Initiator RECEIVE button - will initialize teleport from targetted coordinates
9 - ABORT - will abort initializing teleport
10 - Ship To Shore Communications - displays messages sent over the Ship To Shore frequency
11 - Targeting System ZOOM IN
12 - Targeting System LEVEL UP
13 - Targeting System LEVEL DOWN
14 - Teleporter Status Indicator
15 - Teleporter Power Select
16 - Target Environment Display
17 - LifeForm Scan - Scans targetted coordinates for lifeforms
18 - LOCK - locks the targeting system onto a signal on the Ship To Shore channel
19 - Transmit messages over the Ship To Shore channel
Teleporter Operation:
To operate the teleporter, right click on the chair at the teleporter console to have the avatar sit down and press enter to open the teleporter console window. Left click on the telepoorter power select (15) to supply power to the system. Left click on the Short Range Sensors Active / Passive Select (2) and set the short range sensors to active. Active sensors are required to scan and lock the teleport coordinates.
Left click in the targeting scan window to move the red crosshair to your desired teleport location. The MAG button cycles through levels of zoom. The level up and down arrows allow you to view a particular deck in a ship or structure with multiple decks or levels.
The parties to be teleported should be standing on the teleport pad, and left click on the green send button to teleport them to the location.
To teleport yourself, use the Activation Delay Timer (6). Left click on the timer bar to set an activation delay time. Left click on the green send button, and right click on the teleport pad to move the avatar onto the teleport pad, before the timer runs down.
The shields on the ship or station need to be down, in order to use the teleporter. If your shields are up, the send and receive buttons will be gray.
